Unlocking Key Improvement in Fuel Cells, Electrolyzers

Fuel CellResearchers from Purdue University are making headway on solving issues in electrolyzers and fuel cell development by gaining new insight into electrocatalysts.

Electrocatalysts are key in promoting the chemical reactions that happen in both fuel cells and electrolyzers. However, while activating theses chemical reactions is crucial, the electrocatalysts tend to be unstable and can corrode when used in fuel cells and electrolyzers.

ECS member Jeffrey Greeley is looking to address this issue by identifying the structure for an active, stable electrocatalyst made of nickel nanoislands deposited on platinum.

“The reactions led to very stable structures that we would not predict by just looking at the properties of nickel,” Greeley says. “It turned out to be quite a surprise.”

This from Purdue University:

Greeley’s team and collaborators working at Argonne National Laboratory had noticed that nickel placed on a platinum substrate showed potential as an electrocatalyst. Greeley’s lab then went to work to figure out how an electrocatalyst with this composition could be both active and stable.

Greeley’s team simulated different thicknesses and diameters of nickel on platinum as well as voltages and pH levels in the cells. Placing nickel only one or two atomic layers in thickness and one to two nanometers in diameter created the conditions they wanted.

Read the full article.

“They’re like little islands of nickel sitting on a sea of platinum,” Greeley says.

DISCLAIMER

All content provided in the ECS blog is for informational purposes only. The opinions and interests expressed here do not necessarily represent ECS's positions or views. ECS makes no representation or warranties about this blog or the accuracy or reliability of the blog. In addition, a link to an outside blog or website does not mean that ECS endorses that blog or website or has responsibility for its content or use.

Post Comments

Your email address will not be published. Required fields are marked *